International
Tables for Crystallography Volume D Physical properties of crystals Edited by A. Authier © International Union of Crystallography 2013 
International Tables for Crystallography (2013). Vol. D, ch. 1.6, pp. 153155
Section 1.6.2. Generalized optical, electrooptic and magnetooptic effects^{a}Department of Physics, University of Oxford, Parks Roads, Oxford OX1 3PU, England, and ^{b}Department of Earth Sciences, University of Oxford, Parks Roads, Oxford OX1 3PR, England 
When light of a particular cyclic frequency is incident on a crystal of the appropriate symmetry, in general an electrical polarization may be generated within the crystal. This can be expressed in terms of a power series with respect to the electric vector of the light wave (Nussbaum & Phillips, 1976; Butcher & Cotter, 1990; Kaminow, 1974): where the are susceptibilities of order i. Those working in the field of electrooptics tend to use this notation as a matter of course. The susceptibility is a linear term, whereas the higherorder susceptibilities describe nonlinear behaviour.
However, it is convenient to generalize this concept to take into account other fields (e.g. electrical, magnetic and stress fields) that can be imposed on the crystal, not necessarily due to the incident light. The resulting polarization can be considered to arise from many different socalled electrooptic, magnetooptic and photoelastic (elastooptic) effects, expressed as a series expansion of in terms of susceptibilities and the applied fields E, B and T. This can be written in the following way: Here, the superscripts refer to the frequencies of the relevant field terms and the susceptibilities are expressed as tensor components. Each term in this expansion gives rise to a specific effect that may or may not be observed, depending on the crystal symmetry and the size of the susceptibility coefficients. Note a possible confusion: in the notation , i is equal to one less than its rank. It is important to understand that these terms describe various properties, both linear and nonlinear. Those terms that describe the effect purely of optical frequencies propagating through the crystal give rise to linear and nonlinear optics. In the former case, the input and output frequencies are the same, whereas in the latter case, the output frequency results from sums or differences of the input frequencies. Furthermore, it is apparent that nonlinear optics depends on the intensity of the input field, and so is an effect that is induced by the strong optical field.
If the input electrical fields are static (the term `static' is used here to mean zero or low frequency compared with that of light), the resulting effects are either linear or nonlinear electrical effects, in which case they are of no interest here. There is, however, an important class of effects in which both static and optical fields are involved: linear and nonlinear electrooptic effects. Here, the use of the terms linear and nonlinear is open to confusion, depending on whether it is the electrical part or the optical part to which reference is made (see for example below in the discussion of the linear electrooptic effect). Similar considerations apply to applied magnetic fields to give linear and nonlinear magnetooptic effects and to applied stresses, the photoelastic effects. Table 1.6.2.1 lists the most important effects according to the terms in this series. The susceptibilities are written in the form to indicate the frequency of the output electric field, followed after the semicolon by the input frequencies .

A spontaneous polarization of a crystal can be created in some polar crystals after a strong static electric field is first applied and then removed. Subsequent application of an electric field in the opposite direction can then reverse the sense of the spontaneous polarization. By analogy with the well known similar phenomenon of ferromagnetism, such crystals are known as ferroelectrics (Jona & Shirane, 1962; Lines & Glass, 1979). This effect is therefore not an optical effect, but is included here for the sake of completeness. For a crystal to be a ferroelectric, it cannot have a centre of symmetry.
Application of an electric field of frequency to a crystal results in a polarization response whose size depends on the dielectric susceptibility . This is a secondrank tensor that is applicable to all materials, and is often quoted in terms of the dielectric constant . For electric fields at optical frequencies, the dielectric constant is equal to the square of the refractive index for light propagating in a certain direction and in a particular polarization state. This effect can only be termed optical if the frequency of the electric field lies at optical frequencies. There is no difference between input and output frequencies, and so the susceptibility is written in the form . Because there is no change in frequency, this is a linear optical effect.
This is the phenomenon often known as optical activity (Born & Wolf, 1993; Agranovich & Ginzburg, 1984) in which planepolarized light of frequency passing through a medium has its polarization rotated through an angle depending on the path length through the medium. It is seen most easily along uniaxial directions in crystals with the appropriate symmetry. Centrosymmetric crystals cannot show optical rotation. Because no change in frequency occurs, it can be considered to be a linear optical effect.
If , i.e. the susceptibility is , the resulting polarization is given by This is therefore a polarization induced in the crystal by a strong static electric field. It is a nonlinear electrical effect, and so it is not an optical property.
If and , i.e. , this contribution becomes and corresponds to the situation where light of frequency passes into the crystal at the same time as a static electric field is applied. The effect, sometimes known as the Pockels effect, is to change the polarization state of the incident light, effectively by altering the refractive indices of the crystal. This physical property is governed by the thirdrank electrooptic susceptibility , components , which follow the same symmetry constraints as the piezoelectric tensor. Crystals therefore must lack a centre of symmetry for this effect to be observable. Although this can be classified as a nonlinear effect, because more than one incident field is involved, it is customary to call it a linear electrooptic effect, as only a single electrical field is used, and moreover there is no change in the frequency of the incident light.
It can happen that when two different light fields of frequencies and , such as can be obtained from two lasers, propagate through a crystal, the resulting output frequency can be the sum or difference of the two incident frequencies, through the susceptibility . A particular case is of interest: suppose i.e. , to get Here, the light, on passing through the crystal, interacts with itself to produce a doubling of the frequency. This important effect is known as second harmonic generation or SHG and is used for generating different laser frequencies starting from a fundamental frequency. The observation of SHG is also often a good indicator of the lack of a centre of inversion in a crystal. As two optical fields are involved, the incident field inducing the second one, this is a true nonlinear optical effect.
Another effect can be envisaged in which the susceptibility is , i.e. there is a cancellation of the two incident frequencies to produce a polarization in the crystal. This is called optical rectification.
Parametric amplification is an effect caused when an incident beam at frequency is incident on a nonlinear optical crystal at the same time as an intense pump beam frequency , where . The wave is then amplified accompanied by an `idler' wave of frequency .
This effect, known also as the Kerr effect, results from setting , , i.e. the susceptibility is , thus: Like the linear electrooptic effect described above, a static electric field applied to the medium causes a change in the refractive indices, which then affects the polarization of the transmitted light. The difference here is that the Kerr effect is displayed by all transparent media, including liquids. In an otherwise optically isotropic system, application of a strong static field makes the system optically anisotropic: this change from isotropic to anisotropic can be used to produce a fast optical shutter. Because the light frequency is unchanged, this can be termed a linear optical effect, but on the other hand, because it depends on the square of the static electric field, it is a nonlinear electrical effect.
If and , i.e. the susceptibility is , the resulting polarization is A secondharmonic response is obtained, but this time induced by a static electric field. This is called electricfieldinduced SHG or EFISH. It is a nonlinear optical effect that is created by a linear electric effect.
One use of a thirdorder nonlinear optical susceptibility is in the important area of fourwave mixing. In this case, the complex amplitude of the induced polarization at the frequency is given by Thus if a nonlinear crystal is pumped by two counterpropagating beams of frequency , and another beam is input at some angle, a fourth beam results whose complex amplitude will be the complex conjugate of the beam. Thus fourwave mixing is an important arrangement for producing phase conjugation.
Application of a static magnetic field to certain crystals through which light of frequency passes causes a change in polarization state via The effect is to rotate the plane of polarization of the incident light, the size of the effect depending not only on the length of the medium traversed, but also on the size of the applied magnetic field. An interesting difference from ordinary optical rotation is that on reflecting the light beam back through the medium, the plane of polarization is further rotated rather than cancelled: this property has been used in making optical isolators.
By analogy with the quadratic electrooptic effect, application of a strong static magnetic field can modulate the polarization state of the incident light via This effect is also known as the Cotton–Mouton effect.
Also known as the piezooptic effect (or elastooptic effect), this is usually observed through , i.e. the applied stress is static. Thus the application of a force to an elastooptic material results in a change in birefringence. This effect can be seen not only in crystals, but also in isotropic materials such as glass or transparent plastics. By observation of a stressed material between crossed polars, the resulting strains can be seen as coloured fringes, a useful way of examining engineering structures.
In the acoustooptic effect, the applied stress is at an acoustic frequency , i.e. the relevant susceptibility is . Thus a sound wave passing through an acoustooptic crystal modulates the refractive index via A beam of light of frequency passing through the crystal can then be diffracted by the refractive index modulation, and so such a crystal is a useful device for converting sound waves into an optical signal for longdistance transmission along optical fibres. As , the frequency of the input light is only very slightly altered by the sound wave, and for most purposes can be neglected.
References
Agranovich, V. M. & Ginzburg, V. C. (1984). Crystal optics with spatial dispersion, and excitons. Berlin: Springer.Born, M. & Wolf, E. (1993). Principles of optics. Sixth corrected edition. Oxford: Pergamon Press. Reissued (1999) by Cambridge University Press.
Butcher, P. N. & Cotter, D. (1990). The elements of nonlinear optics. Cambridge University Press.
Jona, F. & Shirane, G. (1962). Ferroelectric crystals. Oxford: Pergamon.
Kaminow, I. P. (1974). An introduction to electrooptic devices. New York: Academic Press.
Lines, M. E. & Glass, A. M. (1979). Principles and applications of ferroelectrics and related materials. Oxford: Clarendon.
Nussbaum, A. & Phillips, R. A. (1976). Contemporary optics for scientists and engineers. New Jersey: Prentice Hall.